Fuse (Vapouriz) Vape Battery Contact Cleaning Tool - Ideally TPU but PLA+ works ok. Also fits most vape batteries with 510 connection (which is most brands now!)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A little helper tool for cleaning out the deep contact recess in these batteries.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 80
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I tried cleaning the contacts with rolled up tissues, rags, cocktail stick, brushes, etc, nothing was ideal. So I designed my own tool for it.
You can use it on its own to loosen up debris and then blow the loosened bits out, or you can use it to poke a single layer of ordinary tissue (face, toilet etc) into the hole. Twist the tool back and forth about a quarter turn each way a couple of times, if you do it too much with a tissue it may leave bits of tissue behind in the hole which you've then got to blow out or fish out with a cocktail stick (DO NOT DAMAGE THE RUBBER INSULATOR!!!).
This Fuse vape type has a nasty habit of rejecting perfectly good atomisers and just flashing its battery light when you try to use it. I thought this was down to bad atomisers but it turns out a bit of muck buildup in just the wrong place in the battery connector can cause it to malfunction - cleaning it out properly can fix it and then it just works again :o)
Can use a very thin bit of scrap ultra-lightweight fabric instead of tissue to avoid any shedding in the hole - I tried some garden fleece that's so cheap it's almost see-through and that worked ok. Don't use a good hanky, it'll leave a mess on it that probably won't wash out and may damage the fabric too.
Any normal print settings should do, I just used Cura's defaults for TPU and it turned out fine. No support or adhesion. 0.2mm layers with a 0.4mm nozzle. The bits that stick out at the end are designed to be 2 x 0.4mm thick so a wider nozzle will probably leave you with only a single wall on the prongs and that's likely to be too weak.
I designed the TPU Dust Cap in the title photo, it's available here…
Please Like this model if you find it useful.
If you REALLY like it, https://www.buymeacoffee.com/gigabeast :o)