Wetsuit Wrangler

This is the Wetsuit Wrangler which is designed for stripping off the sleeves of front zip wetsuits.  The problem it attempts to solve is the challenge of taking off the left and/or right arm sleeves of your wetsuit after expending all your energy from surfing a poor or perfect day. Sometimes, your elbow is your biggest bottleneck in removing that sleeve.

Factors it may also assist with may be:

• Post-surf reduced strength
• Post-surf muscle PUMP
• Lack of balance
• Reduced stamina
• Temporary weight gain (Get ready for that west coast winter swell)
• Loss of flexibility
• Reduced wetsuit material flexibility.

Instructions For Use:

1. All it takes is a few rolls off the wetsuit shoulder to create the hook point for the Wetsuit Wrangler to grab ahold of. 
2. Bend at your knees to step onto the rope or thru the loop. 
3. Stand up and let the Wetsuit Wrangler pull off the stubborn wetsuit sleeve.
4. Store in your trunk or Surf Pack.

Manufacture and Assembly:

• Material: PETG
  • For car or backpack storage.
• Infill: 100%
• Time to Print (0.6mm Nozzle at typical PETG print speed): ~1.5 hours
• Post-Processing: if you have excess stringing in the Ø7.0mm hole, you can insert a tree twig or a drill bit.
   
• Home Depot Visit: 
  • Nylon Rope, 3/16 inch diameter: 
    • 5.5 Feet +0/-1 Feet (for 6' tall and under)
• Assembly:
  • Use a bowline knot on both ends. Or any knot you prefer.
  • As you stand upright, adjust the foot loop so that the starting point of the Wetsuit Wrangler is ranging between waist to mid-forearm height.