1 / 6
Spool Roller with Silica Gel Dehumidifier Built In with Funnel
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed to fit 67mm wide, 200mm diameter spools, or less. Also, has slot for Silica Beads below built in and funnel
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 69
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
- Print list:
Main Body x1
Gel Release Lid x1
Gel Top x1
Spool Roller Support Pin x2
Spool Roller x2
Rear Locking Bar x1
Gel Funnel x1 (if wanted)
Settings will vary by printer, but with my AD5M I did 20% gyroid infill with .2mm layers. Also, I printed in Kingroon High Speed PETG rather than PLA because I feel it holds up better and isn't nearly as brittle as PLA. Main body takes just over 9 hours to print with my settings and all other components other than the funnel take an additional 2.
- Supports
File is designed to only need support on the main body front upper bar. No supports are needed for any other print as long as they are orientated correctly.
- Assembly
a. Insert the gel top from the rear of the main base (sides entire length of body and is held in by a dovetail fitting.
b. Turn main body to lay on it's front face.
c. Insert gel funnel (if printed) to fit in rear of main body and dump in your silica beads or dehumidifier material, being careful not to overfill.
d. Remove funnel if used and while still sitting on it's face, insert the gel release lid to fully enclose the dehumidification material and automatically secure the top gel release lid.
e. With the dehumidification material now secure in the main body. Orient the spool roller on it's base again.
f. Insert spool support pin into spool roller. (Support is designed to stick out of roller slightly on both sides.
g. Repeat step f with the other support pin and roller.
h. Insert front and rear roller bars (parallel to face) all the way to the bottom of their slots. Rollers supports should be only thing resting on the base of the grooves with the rollers sitting on the supports to spin freely.
i. Insert rear support bar to firmly support the back.
j. Insert spool and feed filament through the front hole. It works best if spool is oriented to where the filament is being fed from the bottom.