RPArchive Magnetic Tile Jig for Nickle Strips
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
RPArchive Magnetic Tile Jig for Nickle Strips
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 75
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made a couple of STLs for making the RPArchive 3 inch X 3inch magnetic floor tiles using the green US/NA foam (spongy/springy). These are made for use with .15mmX8mm nickle strips
First use the jig and lightly score around the center square and along the track on each side. Then rotate the jig 90 degrees and score the tracks again.


Then use the press and firmly (but not overly so) press around the edges of the foam with your fingers. I have found it works quite well using a pinching motion with my thumb and forefinger all of the way around.


The result should be a perfectly recessed channel all the way around, 1/16th of an inch from the edge to place the nickle strips.
I hope some folks find this useful. (edited)