1 / 3
Push fit omni-wheel for a geared drive motor — zdjęcie 1
1 / 3

Push fit omni-wheel for a geared drive motor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This adaptation of an existing design allows a complete push-fit omni-wheel to be 3D printed

Ocena
0 / 5
Polubienia
8
Pobrania
55
Wydruki
0
Wyświetlenia
338
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

This adaptation of an existing design allows a complete push-fit omni-wheel to be 3D printed - commercial omni-wheels are readily available but this provides a self-build option, albeit one that is somewhat time consuming to print and assemble.

More detail on the use of omni-wheels is available here and the 3D prints for a complete 3WD robot are available here.

The 3D prints all use  1.75mm PLA and a layer height of 0.15mm with details when produced on an i3 Mk3 shown in the table below.

For the individual subwheels the design needed to be ‘tweaked’ to make the sourced 20-gauge stainless steel wire easier to use, with the insertion hole made slightly flared and the through hole diameter adjusted to suit. To allow others to adapt the subwheel design for their own use, a FreeCAD file is also provided. 

 

component file name/descriptionneeds support (Y/N)brim (mm)filament
length (m)
print time 
(i3 Mk3)
omniwheel_push-on_base01.stl: omni-wheel main hubYN7.893h 34m
subwheel06-solid + r0.52 thru hole + top&btm cones.stl: single individual wheel - 18 needed per wheel.NN0.210m