1 / 8
The Ultimate Dance Pad from 4 to 9 panels with and without bracket — zdjęcie 1
1 / 8

The Ultimate Dance Pad from 4 to 9 panels with and without bracket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A modular dance pad

Ocena
0 / 5
Polubienia
12
Pobrania
36
Wydruki
0
Wyświetlenia
434
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Video Games
Licencja
Creative Commons — Attribution — Noncommercial

This dance pad can mount 4 to 9 panels.

The main features are:

  • Easy pad conversion
  • Support for arcade sensors
  • Easy to wire
  • Seamless and bracket mounting
  • very stable

 

Technical data:

The footboard without a frame measures:  843mm x 843mm (For the base use MDF or 15mm thick plywood remember to add the size of the frame you use to 843mm x 843mm)

the step panel for PIU ( 5 panels )

  • 4x 277x337mm (corner arrows) 10mm polycarbonate
  • 1x 277x277mm (center step) 10mm polycarbonate

the step panel for DDR, ITG, Stepmania ecc. (4 to 9 panels)

  • all 277x277mm  10mm polycarbonate

 

For each panel print the following parts:

  • 4x angle
  • 4x sensor bed (for center step of PIU and all other game) or 2x 2x sensor bed and 2 x long sensor bed (for corner arrows of PIU)
  • 4x top
  • 4x  thickness (only for bracket version)
  • 4x bracket (only for bracket version)

For each panel In addition to the printed parts you will need

  • 4x Connecting screws M4 31-40
  • 4x Arcade pressure sensors
  • 8x 4x30 screw (for lock the frame)
  • 8x 4x20 screw Flat head (for bracket)

The pad has a similar structure to the arcade counterpart.
The sensors should operate with a pressure of about 10 kg.
If you want more or less reactive, just consult the countless guides on youtube dedicated to DDR ,PIU, ITG, Stepmania X and ecc.

For the panel without bracket: 

  1. Drill a hole with a diameter of 6mm in each corner at a distance of 20mm x 20mm. 
  2. After tracing the first hole, use a 10mm drill bit to create a cavity about 4mm deep.

For the panel with bracket:

Cut all corners of about 5.2mm x 5.2mm

Tips:

  • Remember you can go from the no-bracket to the bracket by printing a few pieces, but you cannot do the opposite without purchasing other polycarbonate panels.
  • I recommend printing with 4 walls
  • For the version without a bracket, do not tighten the screw that locks the arrow
  • In case you do not use 10mm polycarbonate, remember to adjust the thickness measurement (2mm higher of polycarbonate)
  • Before proceeding to pierce or cut the polycarbonate, check all the measurements yourself and apply the right corrections.