Octenol Attractant Holder for Flowtron Mosquito Magnets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple insert to secure octenol cartridges without need for tape etc
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 1
- Wyświetlenia
- 85
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Super simple but very useful – the stuff that 3D printing was invented for 🙂
I have a couple of Flowtron mosquito magnets in my yard but replacing octenol has always been a hassle. The cheap octenol cartridges I buy don't come with double-sided tape, and normal tape seems to come off way too easily so the cartridges are always strewn across the yard.
So I came up with this simple holder. Put an octenol cartridge into the holder, then slide the holder into the bottom compartment of the mosquito magnet.
Print with TPU, flat side down, so that it holds in place by friction.
Version History
v1.1: Added model for dual octenol mosquito magnets
If you like what I'm doing…
… consider buying me a coffee or joining my Printables Club.