Dragoon motor mount and firewall jig - 20mm

Slicer settings: Top  layers - 3

                           Bottom layers - 3

                           Infill - 20%

                           Wall lines - 2

                           Infill pattern - Grid

Uses four #4-40 x 5/16 bolts/blind nuts and 2 servo mounting screws.  Uses a ½ inch square stick or the laminated plywood in your kit.  Designed to work with a 42mm x 42mm x 1/8 plywood firewall.  If cutting your own stick, cut the stick flush with the bottom of the mount after the firewall is glued to the stick.  Best suited for motors weighing 80 grams or more and up to a 7 inch prop.  This is the mount of choice for the Sunnysky 2216 2400 kv V2 short shaft and the Xxd 2217 2300 kv.  

The idea is that in the event of an impact, the sacrificial printed mount will break instead of any of the wooden pieces.  Use the large triangle version if you want something more robust.  The small triangle version is more apt to break in an impact but is strong enough for its intended purpose. Happy hunting.