Multifunction velcro tie anchor rail for 21mm accessories
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Screw-mount velcro tie anchor that fits with 21mm slot system accessories.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 37
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Public Domain
Mounts with 2 #6 screws or similar.
The slots are centered 50mm apart horizontally and have 21mm of space between them vertically.
This is coincidentally half of Gridfinity, but is actually meant to allow wrapping around a 20mm extrusion, with a little margin.
The inner channel space is rounded, so you can push a tie through from the front without access to the rear.
The whole thing is 9mm tall, to allow some room for cabling behind the stuff you mount on it.
it is narrower at the base than the front, in case you want to hang something from it.
The horizontal groove helps hold a cable if it is used as a cable tie anchor.
The attachment points are slightly recessed, so that the velcro ties don't get in the way of the accessories sitting flush.
Interestingly, I find that the Velcro nearly pushes itself out of the way when you roll up the excess at the end, which I was not expecting!