SFX backwards mount for Jonsbo Z20
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An alternate way to mount the PSU on the Z20 that points the connectors side towards the cable-management channel.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 84
- Wydruki
- 0
- Wyświetlenia
- 1060
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
These brackets allow an SFX power supply to be mounted with its connector side facing the existing cable channel on the Z20 computer case, in the style of BTS or Project Zero motherboards. This cleans up the interior of the case and might help with airflow. The brackets also offsets the power supply towards the glass-panel side to make enough room for the connectors in the channel and prevent extreme bending of the cabling.
The brackets are designed for Corsair PSUs that use type-5 connectors. Since the mounting-side holes are standard SFX spacing, the brackets could be adapted for use in other cases or other PSU brands. I've included the OpenSCAD original file for remix purposes.
Additional Required Hardware
The dimensions below are for the default bracket thickness of 4mm:
4x M3x25 bolts to mount the PSU+bracket assembly to the case
4x M3 fender washers (optional, recommended) for the bolts above
4 or 6 UNC6-32 x 3/8" bolts to mount the PSU to the brackets.
Depending on the STL you will be using:
(recommended) 4x M3x10mm joiners (female-female standoffs). I used the “uxcell M3 x 0.5-Pitch 10mm Length 304 Stainless Steel Metric Hex Coupling Nut, 10-Pack” from Amazon.
4x M3x5x4 brass heat set inserts (same type as used on Voron printers).
4x M3 nuts
Printing recommendations
Material:
Shouldn't matter, but use something that is heat-resistant enough for the inside of a PC.
Settings:
I used the settings recommended for Voron parts:
- Infill percentage: 40%
- Infill type: grid, gyroid, honeycomb, triangle, or cubic.
- Wall count: 4.
- Solid top/bottom layers: 5.
- Supports: NONE.
If your slicer allows it, set a large brim to “inside only” so the model sticks to the build plate better, without having to do too much cleanup afterwards.