5-to-1 Filament Hub for Anycubic Kobra S1 Combo
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enhanced filament hub replacement for the Anycubic Kobra S1 with ACE Pro system. This 5-to-1 hub allows connection of al
- Ocena
- 4,909 / 5
- Polubienia
- 340
- Pobrania
- 2008
- Wydruki
- 23
- Wyświetlenia
- 13 433
- Oceny
- 22
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This 5-to-1 filament hub is designed to replace the stock 4-to-1 hub on the Anycubic Kobra S1 Combo. While the original hub only accommodates the 4 tubes from the ACE Pro system, this enhanced version adds a fifth port for connecting a manual spool.
Features
- Maintains full compatibility with the ACE Pro system
- Adds capability to manually feed filaments the ACE Pro cannot handle (TPU, specialty filaments, etc.)
- Direct drop-in replacement for the stock hub
- No loss of original functionality
Required Hardware
- 5x PC4-M6 OR 5x PC4-M10 pneumatic fittings
- 1x additional PTFE tube (4mm OD) for manual filament feed
Choose the hub STL file matching your fittings (M6 or M10 threaded). Four fittings connect existing ACE Pro tubes to the hub, while the fifth connects your manual feed tube. Find these parts on Amazon/AliExpress by searching "PC4-M6/M10 connectors" or “4mm PTFE tube.”
Installation
- Remove the stock 4-to-1 hub from your printer
- Install this 5-to-1 hub in the same location
- Connect the 4 tubes from your ACE Pro, make sure to push them in as far as you can
- Connect an empty tube to the fifth port
- Whenever you want to print from the manual spool, turn off the ACE Pro and manually insert the filament through the 5th tube until it reaches the extruder.
Printing Tips
- Recommended materials: PLA, PETG, ABS, or ASA
- Print at 0.1-0.2mm layer height (smaller is better to reduce friction) with at least 15% infill
- Supports might be needed for the two openings at the top
Why You Need This
If you own an Anycubic Kobra S1 Combo and want the flexibility to use special filaments without disconnecting your ACE Pro PTFE tube, this modification is essential. Print TPU or other specialty materials while maintaining the convenience of your multi-filament system.
Changelog
v2:
- Optimized internal tube pathways with smoother curvature to reduce filament friction
- Eliminated sharp edges at tube junctions to improve printability and prevent filament snagging