Mushroom Water Bulb for Bird Buddy Bird Bath
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A "mushroom" shaped water bulb upgrade for your Bird Buddy's Bird Bath.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 541
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
As we upgraded our Bird Buddy with a bird bath, we encountered one small issue. Even the smallest threaded soda/water bottles we could find were too tall to fit under the Bird Buddy roof! These same bottles blocked a good portion of the camera's view as well.
Seeking a solution, I was inspired by the Mushroom Kingdom from Super Mario Bros. and the Mushroom Hill Zone from Sonic 3/Sonic and Knuckles. I created this mushroom shaped refillable water bulb. This 2-piece model requires no supports, and is pre-threaded to screw together with relative ease!
This model pairs excellently with the remixes below:
- Bird Buddy Perch with Bird Bath and Picket Fence Remix by TransBat (myself)
- Bird Buddy Accessories - Perches, Bird Bath, Humming bird Feeder holders by BiggBadaBoom
Given this model will be used outside, I'd recommend using PETG, PCTG, or a similar material.
Alignment arrows are included on both the bottom of the mushroom cap and the mushroom stem so that the holes will pair up and allow water to fill both the stem and mushroom cap.
No supports are necessary.
While all of my test prints did not need it, you may find a small brim helpful for the mushroom stem given the limited portion that touches the bed. Of course, your mileage may vary ;)
Assembly:
- Screw the two threaded pieces together
- When the stem ring enters inside the small recess of the mushroom cap, the arrows will align
- At this point, you should be able to turn another quarter turn so the arrows line up again, and hear a satisfying/loud click
Note:
Depending on your printer/material tolerances, you may wish the apply a small ring of glue in/around the recess of the mushroom cap to create a water-tight seal between the two pieces.
The provided BG code was prepped on my Prusa XL using stock settings in PrusaSlicer 2.9.2:
- 0.2m structural preset with Input Shaping
- 5% Infill
- Jessie PETG
Feedback is welcome - happy printing!