5.8Ghz Cloverleaf Antenna Protector(2gms)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple antenna protector that I designed.The primary objective was to keep it light and very strong.I…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 217
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a simple antenna protector that I designed. The primary objective was to keep it light and very strong. I designed it for the AOMWAY 4-leaf clover antenna, but should fit all 5.8ghz antennae which are the same style. There is a lot of people who agree that the video quality of this antenna is the best value for money! and everyone agrees that the antenna in its OEM form does not survive a lot of crashes!
Print Settings
Printer Brand:
Prusa
Printer:
Prusa Clone
Doesn't Matter
Supports:
Yes
0.2mm
Infill:
20-30% (does not matter)
Notes:
Print 2 identical copies that make the two halves of the antenna cover.
Post-Printing
Assembly
The antenna is printed in two halves. I suggest just holding the two halves together and run thin CA along the joint. A small spray of CA accelerator (kicker) is of great help.
Remember, the base should be snug against the semi-rigid coax cable for the antenna.
Additional strengthening (recommended)
Drill a small hole on the top and fill a small amount of moisture curing PU adhesive. This would Expand and fill up the cavity. This enormously increases the strength and durability of the antenna case.
Category: R/C Vehicles