Creality Ender v3 SE - Falkon 1 Laser Module Holder

Ive created this Falkon 1 Laser Module holder for the Creality Ender v3 SE to have the laser centered below the print head. When the Z-axis is moved up, it allows for 6cm height below the laser with honeycomb and 8cm without it.

The print was done with 0.2mm nozzle with 0.12mm layer height and 15% infill density. It takes about 3.5 hours to print. Since the model would not fit most print beds, tilt it by 45 degrees to make it fit. Ive attached a picture to show the correct printing position.

The laser holder is rock solid in the X-axis direction, no wobbling, very good laser engraving/cutting results. Ive used a cable tie to attach the laser to the holder to avoid wobbling in the Y-axis. The holes are 3mm each. Remove the original screws from the print head cover and use three M3x10mm screws to fix the holder onto the print head. Do not use longer screws.

General Falkon mounting/operating instructions: Since the Ender v3 SE is not officially supported for the Falkon 1 laser module, you need to open the Ender v3 SE case at the bottom to find the motor for the y-axis at the FRONT of the printer, not in the back. The case can be manipulated to create a small opening at the bottom front (see picture). Attach the extension cable, this way you can swap between 3D printer and laser mode without opening the case every time. You only need the 6pin connectors from the Falkon module for the motors. When working with Lightburn, go to the console and set §3=2 to adjust the axis inversion. Knowing this before would have saved me quite some trouble ;)

Have fun!