Pedego electric bike battery holder and wall mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a wall mount for a Pedego electric bike battery. You can print as a single unit or in two halves for smaller…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 380
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a wall mount for a Pedego electric bike battery. You can print as a single unit or in two halves for smaller print surfaces. Optionally, you can keep the battery holder on the ground against a wall and use the optional stability feet to keep the battery holder from falling forward, etc.
For the interlocking two halves version, it will require some sanding of the tabs so they fit into their slots. Once you get them flush, it’s reasonably stable and effective.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
200
Infill:
15
Filament:
Prusament PLA
Notes:
Use supports only for interlocking two halves version.
For the two halves version
Sand the tabs that stick out until each one can fit into their slotted counterpart perfectly flush.
Category: Electronics