Simple Station for AeroPress

Updates

4/28/2026

- uploaded additional "narrow" version of the original model per request, which now has a width <220mm

5/26/2025

- added additional clearance to the stirrer stick slot on the Alt model to accommodate the wider version of the stirrer from AP

5/17/25
- updated some clearance areas for better fit for main model
- minor cosmetic updates e.g. fillets on bottom grill, additional chamfers where it made sense
- added “Alt” model version with slots for the AP scoop and stirrer

Overview

This minimalist station is my storage and drying solution for my AeroPress at home. The AeroPress lived in my dishwasher dry rack more than I'd like to admit, so this station was created as both a dry rack and storage solution for my setup. I don't use the scoop or agitator that came with the unit in my personal workflow, so those items have been omitted which further reduces the footprint.

This model can hold a standard AeroPress (both plunger and brew vessel), a stack of filters, and your cap of choice (in my case, the Flow Control cap from AP). 

Printing

I printed mine with a fuzzy skin texture for aesthetics and used PETG with 3 outer layers. Default settings and any other filament should be fine, though. This model is fully printable without supports if your printer can handle bridges well. It should be oriented on it's back for best printability, as shown in the attached .3mf file.

If would like to support me and future project updates directly, you can Buy me a coffee or PayPal directly.

Enjoy!