Vase(with writing option)

Hi, this upload was a little late. :( This is a nice vase that you can put basic stuff. There are two versions, with writing and without writing. 

In this, I carefully made the size so that it would not look too big, but also not too skinny. I also made the lip open a little so it has a nice look. 

Here are the settings I tested with

• 0.2 layer hight
• No supports 
• Brims(Because my printer has BAD bed adhesion)
• 0.4 wall thickness
• 0.6 top and bottom thickness
• 10% infill
• Cubic infill
• 180mm/sec speed

Here are the slicer settings I recommend:

• 0.2mm layer hight
• No supports
• Brim (only if you have poor bed adhesion)
• 0.6 wall thickness
• 0.6 top and bottom thickness
• You choose infill percentage
• You choose infill type(not hollow)
• Your own speed

Side note

My printer has some BAD bed adhesion so I adjusted some settings to improve it. 

Note:

 If you like this model, show your support by downloading the model. 

If you appreciate my work, smash the like button.

If you are all of the above, smash the like and the download button.

Feel free to leave a suggestion in the comments so I can make this even better. :)

!!!!!!Thank you!!!!!!

You can also find this model on Makerworld under my account.

P.S. I gave this to my mom and she LOVED it. :)