Power Rangers Turbo Turbo Blade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Power Rangers Turbo/Gekiso Sentai Carranger prop
- Ocena
- 0 / 5
- Polubienia
- 33
- Pobrania
- 161
- Wydruki
- 1
- Wyświetlenia
- 556
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial
Print Settings
- General Settings
- Infill: 3%
- Sparse infill pattern: Grid
- Wall loops: 2
- Support: Tree
- Brim Type: Outer brim only
Parts list
- Sword
- 1 5/16 threaded 36 inches long (914.4 mm) or wooden dowel
Length of sword: ~39.5 inches (1003.3 mm)
Length of sword including ripcord: ~41.5 inches (1054.1 mm)
Printing Instructions and Assembly Instructions
I block supports in the rod clearance of the blade tip and holes in blade_pt_4. It saves a little material, and you won't have to fight it out later.
Orient the pieces any way you want. I print the handle standing straight up on the rounded end to avoid splitting it. The rop_cord can be split in half to give you flat surfaces to print on.
You'll be printing 4 of the link_pipe that go into the holes on the blade. Insert the long end into the blade and push them all the way in. They need to be inserted before you fix the blade to the guard, but don't glue them down yet. Once the blade and guard are glued up, you can drop a little adhesive in the channels on the guard and slide the link_pipes back into the guard.
Be careful when dry-fitting the parts. The fan can be hard to remove if you dry fit it to the guard with the pin. If you go with the wooden dowel instead of the threaded rod, you'll need to do a little bit of work as well. You'll need to sand down the dowel until it fits. I recommend beveling the edges as well. You can do this while dry fitting the parts to make sure the dowel doesn't get stuck.
Also including a mostly fully assembled version of the sword as well for scaling. The only missing part is the rip_cord which can be scaled and printed separately.