Two-part Drumstick Holder (6–8 drumsticks)

A two-part drumstick holder for vertical 1.5" (38.1 mm) drum rack tubing or any vertical tube between 20 and 45 mm. The inner diameter of the holder cup and ring is 7 cm (2 3/4"), so it can hold 6 to 8 drumsticks (a smaller version for 4 drumsticks is available here). It clamps onto the tubing using M6 bolts (4 pcs in total) and standard M6 hex nuts (10 mm span of the nut flats) that are inserted into the hexagonal slots from the inside of the holder. The clamping bracket is the same for both the ring and the cup so you will need to print the same part twice.

There are two separate, mutually incompatible versions, one for the 1.5" (38.1 mm) rack tubes and one universal, which should clamp to any tube between 20 (maybe 19) and 45 mm. The rack version uses M6x40 mm bolts, the universal one needs M6x30 mm bolts for 20 mm and M6x60 mm for 45 mm tubes, interpolate if you are in between :)

Print instructions

Designed to print vertically (as shown in the renders) without supports. For the rack version, I suggest printing one mounting bracket first, test fitting it onto your rack tube and then adjusting the scale for the rest of the parts if necessary.