Nerf DragonPower Fireshot Tacticool Mods
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made these parts for a Nerf DragonPower Fireshot mod, MGK-MSL3. Watch the build video here: https://youtu.be/3py-…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 256
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Made these parts for a Nerf DragonPower Fireshot mod, MGK-MSL3. Watch the build video here: https://youtu.be/3py-mhcekac
Not much hardware needed for the parts. About 160mm of 10/32 threaded rod and nuts, 50mm of 17/32 brass and 9/16 brass. The rod and nuts are used for the plunger. The brass is for the barrel and muzzle. The 9/16 brass should fit into the front of the muzzle (flat end) and slide all the way to the base (slanted end). There should be a groove at the base of the muzzle where you can put a dab of your adhesive of choice to secure the 9/16 brass. I used Gorilla Glue and let it cure overnight. The 17/32 brass should fit nice and tightly into the stock barrel.
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
Variable based on part
Filament: Gizmo Dorks PLA Copper
Notes:
Use your best judgement for infill and supports. I usually print at 30% with 5 walls. I think I did 90% with the tac rail. 100% for the plunger parts. I also used MatterHackers Translucent Green PETG for the priming bar.
Category: Other