Flashforge Adventurer 5M X1 Hotend Conversion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Conversion for the Flashforge Adventurer 5M/Pro to use Bambu Lab X1/X1C hotends.
- Ocena
- 5 / 5
- Polubienia
- 88
- Pobrania
- 295
- Wydruki
- 5
- Wyświetlenia
- 3157
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
Hi everyone! I've been working on this conversion for a while. The overall objective was to allow the AD5M/Pro to utilize X1/X1C hotends, and also to reduce the noise of the printer overall.
You will need:
- An X1 or X1C hotend
- A 4 pin JST connector for the hotend
- A 30x15mm 24v fan (with a 2 pin JST connector)
- 1x M3x20 coarse/plastic screw for the fan
- 9x M3x5 thread inserts
- 2x M3 nuts, 2x M3x20 bolts/screws for the hotend
- 4x 5x2mm magnets
*CLEARANCE WARNING* I have a Garolite plate adhered to a stock PC plate, the fan shroud may contact the build plate handle. Double check clearance before printing.
You may also utilize the stock grey cover, but you will need to trim the clips on the sides that lock into the stock body.
You will need to take a very small drill-bit to clean out the filament 'tube' between the extruder and hotend.