Voron Trident Mount for 4.3" BigtreeTech TFT Screen (Clicky-Clack Door Compatible)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This touchscreen mount has clearance for the clicky-clack door, hides the DSI cable and has brightness buttons.
- Ocena
- 5 / 5
- Polubienia
- 16
- Pobrania
- 89
- Wydruki
- 3
- Wyświetlenia
- 487
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Overview
This mount is for the 4.3" BigtreeTech TFT touch screen with the micro-switch brightness buttons. It has 2.5mm clearance at the top for the clicky-clack door mod and sits flush with the door in the front. The mount is thick and wide enough so that the DSI cable fits inside without bending it too tightly. There are push button tabs at the bottom left that provide convenient access to the brightness adjustment buttons.
Printing
I used the setting recommended in the Voron manual, there are no slicer generated supports required. The model has a small built-in support for the button tabs that needs to be cut after printing.
Hardware and Assembly
The mount uses the 4 screws included with the BTT panel to attach the TFT screen. The faceplate is secured to the mount by two M3x6 button head screws, and the whole assembly is fastened to the 2020 extrusion by two M3x8 socket head cap screws and corresponding roll-in T-nuts.
Attach the DSI cable to the panel first, being careful to get the orientation correct. Cut out the support layer at the front of the two push button tabs. Carefully insert the panel into the face plate with the buttons against the tabs. Next, attach the mount to the outer four mounting studs on the panel using the screws that came with the panel. Then, secure the face plate with the two M3x6 screws to the mount. Do not over-tighten. Finally, push the roll-in nuts into the extrusion and mount the whole assembly using two M3x8 screws. Note that due to the print orientation, the key that goes into the extrusion does not really do much for aligning the panel, so make sure to align it to the door before fully tightening the screws.