1 / 4
Hoover Holder! Or Vacuum Vice if you will — zdjęcie 1
1 / 4

Hoover Holder! Or Vacuum Vice if you will

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A bracket and clip that screws into the wall to mount your hoover's tube on, for storage. Ours kept getting in the way…

Ocena
0 / 5
Polubienia
1
Pobrania
10
Wydruki
0
Wyświetlenia
219
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial

A bracket and clip that screws into the wall to mount your hoover's tube on, for storage. Ours kept getting in the way in the pantry, so I was tasked with finding a solution!

  • Fits a tube of roughly 36mm diameter (35.6mm I think mine measures as).
  • I've stuck a small rubber pad underneath the clip to stop it sliding down, but it is pretty tight. Needs a good shove to get it over the tube to start with.
  • Fixed to the wall with two 7mm diameter head screws with a 4mm deep countersunk hole.

The bracket for the wall I printed upright with supports only on the lugs that stick out for the screw holes. The screw holes I didn't bother with supports as they're quite small. They came out a little distorted due to the overhang, but nothing too bad - it's hidden by the screws anyway. The clip itself can be printed upside down so no issues with supports there.

Infill was set as 25% and 0.2mm layer height seems to work well.

I had made a few prototypes and over a month the clip started to loosen. I increased the clip size and it seems to be doing well so far! Maybe for version 2 I will use heat set inserts to add a bit more stability and grip to the clip.

Category: Organization

Tagi