Fiat 500 7" Android stereo vent
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fiat 500 2007-2015 basic vent redirect for aftermarket 7" Android stereo/head unit
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 261
- Wydruki
- 0
- Wyświetlenia
- 1281
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
Aftermarket stereos/head units for pre-facelift Fiat 500 (years 2007-2015) usually require removing original diffuser and vents which leads to air blowing into the back of the screen and everywhere under dashboard.
This model is not as fancy as the redirect for 9" stereos, but gets the job done - redirect the air (or most of it since it isn't flush) into the cabin. You can glue foam seal tape to the back of the head unit screen and/or to the sides of the vent if you want a better seal or more pleasant look - I have used 5mm thick × 10mm wide tape for windows.
Print vertically with supports under mounting plate. ABS or PETG is recommended (or anything that is durable and will work under sun heat). Mirror model for the right side vent during slicing. Screw it into the stereo mount if you wish, but it sits quite tight by itself.
At the time of publishing I have tested this with two similar Android units (the only visual difference was knob vs buttons on the left, the knob one didn't sit flush with the dashboard by itself) and there is a noticeable difference of airflow between no redirect and with redirect.