1 / 4
Skewer But Long (Full Length Skewer)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of the Charamile Designs Skewer for full length darts.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 16
- Wydruki
- 1
- Wyświetlenia
- 196
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (14)Wydruki i komentarze (Wydruki: 1) (Komentarze: 3)Remiksy (1)Kolekcje (9)Powiązane
The Skewer But Long is a remix of the Charamile Designs Skewer that uses full length nerf darts instead of half length darts.
There are two ways you can use these files:
- Print all of them, then use the standard skewer file set for the rest of the parts. Do this if you want the smallest full length skewer possible.
- Print only the magwell and dart guide, then use Sillybutt's Harpoon remix for the rest of the parts. Do this if you want to use a Caliburn ram or Caliburn springs.
The only hardware differences between the different versions are as follows:
| Skewer | Skewer But Long | Harpoon | Full length Harpoon | |
|---|---|---|---|---|
| Main threaded rods | 13" | 15.3" | 17" | 18.4" |
| T-pull threaded rod | 9.5" | 10.4" | 14" | 14" |
| T-pull aluminum tube | 7.13" | 8.02" | 11.6" | 11.6" |
| Plunger tube | 5.2" | 5.6" | 7.31" | 7.31" |
| Ramcore | Talon Claw | Printed | Talon Claw | Caliburn |
| Spring | 5" | 6.75" | 11" | 11" |
Assembly and print instructions are the same as the original Skewer.
Some tips on the printed ram:
- Print it vertically.
- Use a brim. It will fall over otherwise.
- Use a fine layer height (0.1mm or finer). If you have a 0.2mm or 0.25mm nozzle, use that.
- No, it will not break. I use printed rams in almost all of my blasters, and they've endured lots of gameplay and many jams with no breakage.
Licensing
This model is licensed under the Creative Commons - Attribution - Noncommercial - Share Alike license. Contact Taffy if you want to sell hardware or prints for this model.