1 / 6
Star Wars OnTop for Pen (TIE + R2D2) - Star Wars Aufsatz für Kugelschreiber (TIE + R2D2) — zdjęcie 1
1 / 6

Star Wars OnTop for Pen (TIE + R2D2) - Star Wars Aufsatz für Kugelschreiber (TIE + R2D2)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Star Wars OnTop for Pen (TIE + R2D2) - Star Wars Aufsatz für Kugelschreiber (TIE + R2D2)

Ocena
0 / 5
Polubienia
9
Pobrania
65
Wydruki
1
Wyświetlenia
535
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Star Wars OnTop for Pen (TIE + R2D2) 
 

Attachment for the Ballpoint pen Gyroid + Cubic:

https://www.prusaprinters.org/de/prints/126323-pen-gyroid-cubic-with-holder-kugelschreiber-gyroid

Simply swap the screw and put the OnTop in the holder.

Don't be surprised if the OnTop goes a little harder into the holder of the screw. This is normal and ensures that the OnTop is securely fastened in the screw. If the OnTop is too loose, simply fix it with a drop of superglue.

The lower part of the screw (5-16mm) should be printed with 0.10mm because of the thread and the rest can be printed with 0.2mm (Prusaslicer: height range modifier).

Stl-Files (without configuration)
3mf-Files (with configuration) for MK3S and Mini 
Printfiles (G-Code) for MK3S and Mini

Have fun and may the force be with you!

 

Star Wars Aufsatz für Kugelschreiber (TIE + R2D2)
 

Aufsatz für den Kugelschreiber Gyroid + Kubisch:

https://www.prusaprinters.org/de/prints/126323-pen-gyroid-cubic-with-holder-kugelschreiber-gyroid

Einfach die Schraube tauschen und das OnTop in die Halterung stecken.

Wundert euch nicht wenn das OnTop etwas schwerer in die Halterung der Schraube geht. Das ist normal und sorgt dafür das das OnTop stabil in der Schraube befestigt ist. Sollte das OnTop zu locker sitzen dann einfach mit einem Tropfen Sekundenkleber fixieren.

Der untere Teil der Schraube (5-16mm) sollte wegen dem Gewinde mit 0,10mm gedruckt werden und der Rest kann mit 0,2mm gedruckt werden (Prusaslicer: Höhenbereich Modifizierer).

Stl-Dateien (ohne Konfiguration)
3mf-Dateien (mit Konfiguration) für MK3S und Mini 
Druckdateien (G-Code) für MK3S und Mini 

Viel Spaß und möge die Macht mit euch sein!

Tagi