Filament Storage Container - Australian/Kmart edition

I wanted a way to store my filament with desiccant and a humidity gauge.  I couldn't find local so I sent the missus on a mission to bring me back a new container each time she went to Kmart and we found these.

They appear to seal and stack well, as well as have plenty of room for 1kg spools.  I have tested eSun, Sunlu and Creality plastic/paper in the holder and all fit.

Parts Purchased

4.6L Modular Food Storage - Kmart

https://www.aliexpress.com/item/1005007960824587.html?  (If you want the humidity gauge, they're VERY low quality but do appear to do their job of showing when humidity is above 30%)

Printed Parts

You'll want a ‘Container Stand’ for each container.  

If you plan to use the container for loose desiccant beads, then you'll want to print a ‘desiccant storage’ bucket.  There are 3 options, the difference is in the lip size for it to lock into the holder.  I recommend 1mm, if it's too hard to push the desiccant holder into the spool holder try the 0.75mm, if it's too loose, try 1.25mm. 

The panels you can print as you like/want.  I recommend printing out of the filament that is being stored in the container for easy spotting.

Print Setup

I print in this orientation for each part:

The desiccant storage is easy, just print without supports.  Add a brim if you need it for bed adhesion, I didn't.  

The best settings I have found for the stand is:
0.24mm Layer Height
3 Wall loops
5% infill, Gyroid
Tree(auto) - Hybrid Support
30 degree threshold angle

Whatever speed you want, although I added a 50% slowdown near the top as the vertical bars were starting to wobble, I resumed to 100% when the top had connected all the bars up.

I blocked supports here also, the support for the desiccant storage is built into the part.  I remove it with a pick tool.

Hope this helps!