1 / 3
Makita router attachment (edge series, single-handed 3700 etc.) for dust extraction from below. — zdjęcie 1
1 / 3

Makita router attachment (edge series, single-handed 3700 etc.) for dust extraction from below.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Makita router attachment (edge series, single-handed, 3700 3711 3712, etc.) for dust extraction from below the foot.

Ocena
0 / 5
Polubienia
4
Pobrania
44
Wydruki
0
Wyświetlenia
370
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

An unusual chip extraction attachment - screwed underneath, to the foot, for edge work. 

Typical top extraction (i.e. between the milling machine and the foot, pulling the chips upwards) do not remove the spoil well when working with a long edge milling cutter. A lot of dust flies down and to the sides. 

I designed such an accessory that collects dust around the milling cutter, not allowing it to fly in all directions. It covers the cutter and its work area, extracting dust directly from the place where it is created.

One-handed (edge) Makita milling machines (and many clones) have a foot with a hole spacing of 62mm x 70mm, M4 screws. This attachment is adapted to such a base. The holes are adapted for mounting in both spacing, you can work on both sides. 

On the sides, in the place for the extraction pipe, there are two holes, designed to press in heat inserts (typically M3 4x5), so that you can squeeze the pipe with two screws from the sides. Or for another way of attaching the vacuum cleaner pipe, so that it does not fall out, even with a nail through it.

The vacuum tube (the hole for it) is 32mm, typical for home vacuum cleaners. Of course, you can also insert any adapter for a different diameter of the exhaust pipe here. 

Larger milling machines, such as the Makita RT0700 RT0701 RT0702C etc. - have a smaller (!) spacing of mounting holes in the base (45mm x 56mm) - I also have such a base designed for this version, check my  models.

Tagi