Radiation shield for expLORA CLIMA OUTDOOR
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This printable enclosure is tailor-made for a wireless expLORA CLIMA OUTDOOR sensor
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 386
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This printable enclosure is tailor-made for a wireless expLORA CLIMA sensor with a 868 MHz LoRa radio (powered by two AA batteries). It provides a rugged, well-ventilated housing for long-term temperature, relative-humidity and barometric-pressure monitoring indoors or out.
Key features
- Perfect fit – seats the PCB, battery holder and antenna precisely
- Support-free design – prints with clean overhangs.
- Ventilation grid – smart louvers speed up sensor response while shedding light rain.
- Quick maintenance – lid pops off in seconds; battery swap requires zero tools
- Outdoor-ready – drainage grooves and raised lip reduce water ingress; PETG/ASA recommended.
Additional hardware: You’ll also need four 12 cm M5 threaded rods to act as standoffs and four matching nuts—preferably wing nuts so the lid can be secured or removed quickly without tools.
Full print including sensor is available at https://pajenicko.cz/bezdratovy-senzor-explora-clima-outdoor