CKC2025 Badge Shell
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A shell for the brilliant badge from CKC2025, which protects the board and makes the device look like a Tamagotchi
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 13
- Wydruki
- 1
- Wyświetlenia
- 45
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
A shell for the brilliant badge from CKC2025, which makes the device look like a Tamagotchi.
Built with a little bit of extra tolerance, partially for the sake of my printer, and partially because I threw this together in an hour or two.
- Requires one M5x12mm machine screw to hold the front and back plates together.
- I recommend placing small pieces of paper in the four reliefs for the neopixels to dim them a little bit.
- The vibration motor should be attached on the back of the board, anywhere under the battery.
- You may also need to unstick your battery from the back of the board.
Without modifying the board or making the whole product way bigger, there wasn't a good way to get more than one bolt in this design. There's a small clip at the bottom to hold things together. If you're already throwing scraps of paper into the design, put some between the front/back plate above the screw to provide some leverage, or throw some glue in the clip.
This could definitely be improved with more time. Let me know if you have any suggestions.