1 / 7
Parametric Fabric Tape Measure Spooling Case
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Turn your ordinary fabric measuring tape into a full on tape measure, with this fabric tame measure spooling case!
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 16
- Wydruki
- 1
- Wyświetlenia
- 107
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
MEASURING:
- Tape height. Affects the height of the housing and consequently the height of the roller and all slots.
- Length (along the ribbon) of your tape tip. (if you have one) if not - specify as 10mm and fold the tape 2-3 times. Affects the width of the groove in the roller and the diameter of the roller core.
- The size of the housing, made up of the thickness of the roller and the thickness of the wound tape. (Measure half a roll of tape, multiply by 2, add the tip value from 2 to the result).
- The thickness of the tip of your tape. If you have a tape without a tip, measure the thickness of the roll obtained in the previous step.
- The thickness of the tape itself. Should be less than the thickness of the tip if you don't want it to fall through the body.
Additional settings:
- hole deep thickness - height tolerance so that the roller can rotate. The more precise your printer, the smaller it is. On a bambulab, 0.1-0.2 is sufficient. (You can sandpaper the roller foot to make a little more room for the roller.)
- Quality - 32 or 64, with high quality round holes are "rounder" but the final model file will be heavier.
- Ring - to create or not a ring for suspension.
ASSEMBLY:
- Print the case and roller.
The case needs no supports and should have 3+ perimeters\solid top\bottom layers dor durability.
The roller does need supports, since it has overhangs, but can be printed with a lower infill.
Work fine with 5-10% infill and 2-3 perimeters\solid layers.
- Fold the tab at the end of the tape and insert it into the T-shaped notch in the roller.
Be sure to use the high number end of the tape so that the zero end comes out of the dispenser.
Also, be sure you have the numbers upside down, since this piece will be inverted in the coming steps.
- Place the spool into the case, and thread the tape through the mouth near the corner of the case.
- Snap the case together!
- Crank the roller to gather the tape onto the spool!