Rising feet for Atomstack X24 Pro
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Raises an Atomstack X24 Pro 5cm up.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 106
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed my X24 Pro to be raised a bit and the only solution I found in the net was for a rotary tool, which I do not have. I just wanted by laser head to be able to go a bit lower so the tubes aren't scratching on the top of the housing. So I designed some foot which raises the X24 5cm up. (about 2 inches).
Additionally, to prevent any fumes (or at least most of them) coming out beneath the X24, I framed it with wood planks all around. That's what the little sticks and the wall on the sides of the feet are for. You just slide in some wooden boards (I used birch, 60mm high, 10 mm wide, painted it black). To close the tiny gaps on the top I put some foam band with 1mm thinkness on the upper part. The boards are not attached, just slided in. With that you can remove them easily if you want to moved the whole setup or if you want to put in a somewhat larger material.
For me it works perfectly.