1 / 2
Taillight mount and fender for QuickTrack MTX rear bike rack — zdjęcie 1
1 / 2

Taillight mount and fender for QuickTrack MTX rear bike rack

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Attach a saddle-post taillight and fender onto the back of a QuickTrack MTX / MTX 2.0 rear bike rack.

Ocena
0 / 5
Polubienia
6
Pobrania
11
Wydruki
0
Wyświetlenia
139
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This mount lets you attach a saddle-post taillight onto the back of a QuickTrack MTX 2.0 rear bike rack. It includes a mini-fender that serves as a flange to prevent the taillight from slipping off, and the fender also protects the tailllight (and you) from debris thrown by the rear tire.

This is similar to my previous Delta rack design, adapted for the QuickTrack MTX. This taillight and fender design should be compatible with both QuickTrack MTX and QuickTrack MTX 2.0 rear bike racks.

Hardware required:

  • 3 M4 screws, 15 to 16 mm long
  • 3 M4 lock nuts with nylon locking (metal locking may damage the plastic)
  • 3 M4 washers

Tools required:

  • Screwdriver or hex driver (depending on screw type)

 

Print Settings

Printer: Prusa MK3S

Supports: Yes - and use a brim too!

Resolution: 0.2 mm layer height, 0.4 mm nozzle

Infill: 25% adaptive cubic, 4 perimeters

Filament Material: PETG

Notes: 

Requires supports from build plate only; the "snug" or organic/tree support setting in PrusaSlicer is recommended. You don't need supports on the diagonal edges; suppress them or set the support angle until they disappear. The fender edge has a thin contact area with the build plate, so use a brim to prevent warping from lifting the edge as it prints.

Installation

  1. Before mounting, if the nuts don't slide easily into the hexagonal holes in the taillight mount, force the nuts into the holes by inserting the screws in one end and screwing them all the way in to pull the nuts into their hexagonal holes. Then unscrew the screws. The nuts should stay in place.
  2. Likely unnecessary because the MTX rack is pretty tall: If the rack is already installed on the bike, you may need to loosen the rear wheel to slip it downard a bit, to make room for you to slide the taillight mount behind the mounting tab of the rack. Re-attach the rear wheel.
  3. Position the mount on the front side of the rear metal tab, insert screws into the tab holes from the back side of the metal tab until they engage the nuts embedded in the mount, and screw the mount onto the rack.

 

Category: Sport & Outdoors

Tagi