1 / 2
Small Songbird Birdhouse - Easy To Print, Even On A Small Printer — zdjęcie 1
1 / 2

Small Songbird Birdhouse - Easy To Print, Even On A Small Printer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a small birdhouse, with a geometry optimized for songbirds such as wrens, finches and chickadees.

Ocena
5 / 5
Polubienia
51
Pobrania
217
Wydruki
2
Wyświetlenia
833
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is a small birdhouse, with a geometry optimized for songbirds such as wrens, finches and chickadees. It's small enough to print on a printer with a 150x150x150 mm build volume. It's a very simple one piece print that requires no supports. The design excludes larger birds that may be predators. It's lightweight but very strong, with insulating air pockets in the floor, walls and roof to protect your feathered friends from excessive heat or cold. The overhanging front porch roof shields the door opening from sun, wind and rain.

The best time to hang a birdhouse is late winter so it's available when birds are nesting in the early spring, but you can hang a birdhouse any time of the year and birds will move in whenever they need a new home. Simply use two decking screws to hang the birdhouse in a shady area away from traffic, high enough to avoid ground based predators. Some bird species will raise two broods of chicks in the warmer months before migrating. After the birds leave for the winter, it's easy to clean this birdhouse with a garden hose in the opening to flush out the old nesting material. There are three small drain holes in the floor.

I used white and light tan PETG because it resists sun and rain. Darker colors would quickly overheat if exposed to direct sunlight. Print with the floor of the birdhouse on the print bed. DO NOT TRY TO PRINT IN THE ORIENTATION SHOWN IN THE GENERATED IMAGE AS THE FRONT OF THE BIRDHOUSE WOULD BE UNSUPPORTED.

I included the STL file so you can slice your own, the FreeCAD FCStd file if you'd like to modify the design, the generic OrcaSlicer 3mf file so you should be able to easily slice the part for your own printer making any changes you like.  I tried to include two G code files if you happen to have a Sovol Zero 3D printer, one with texture and one without, but Printables still doesn't like the START_PRINT command that OrcaSlicer generates.  Those files are on my Thingiverse account, with the same title. The textured surface looks more natural in an outdoor setting but increases the print time by almost two hours.

PETG, ABS, ASA - Any light color
0.4 mm nozzle
0.2 mm layer height
2 walls/perimeters with additional wall/perimeter on alternate layers
10% gyroid infill for thermal insulation

Category: Outdoor & Garden

Tagi