1 / 14
Yamaha MG10XU Mixer and BMS-10A mic stand adaptor easy attach and release mechanism — zdjęcie 1
1 / 14

Yamaha MG10XU Mixer and BMS-10A mic stand adaptor easy attach and release mechanism

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Tired of spending 10 minutes to attach and release your mixer from the stand and losing the screws in the stand's bag...

Ocena
0 / 5
Polubienia
4
Pobrania
23
Wydruki
0
Wyświetlenia
421
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Audio
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Tired of spending 10 minutes to attach and release your mixer from the stand and losing the screws/washer on the floor or the stand's bag...attach these 2 parts more or less permanently to your mixer and stand adaptor and then just slide them together and you're ready to go in a second or 2 (maybe 3 for the casual sloths).

Print all parts in the orientation provided and no supports will be required.

Mixer module:

You'll need 2x M5 screws with countersunk heads to attach the mixer part to the mixer.  If you need to stand the mixer on a desk or similar space you might want to add some rubber feet.  If your top layer is not really smooth perhaps glue will be needed for this.

NOTE: Added updated v2  with softer edges on 7 Aug 2026

Stand adapter module:

You'll need 2x M5 heat inserts with 7mm outside diameter to attach the stand part to the stand mic adaptor.  I used 10mm inserts as the adaptor screws are 10mm long but you should be able to use anything shorter up to about 6mm as well.  Longer than 10mm and you risk the screw going too far and hitting the part on the mixer and making the fit more difficult.  The holes in the part is 7mm diameter so if you get anything bigger you need to adjust the hole size.  Heat inserts should be inserted from the bottom.  I had to use the 12mm high part for the adaptor as one of the the screws caused an issue for me, but I added a 10mm for those who want to try.

 

Tagi