1 / 5
Age of Sigmar Battle Box organiser v1 — zdjęcie 1
1 / 5

Age of Sigmar Battle Box organiser v1

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An overengineered battle box for Age of Sigmar which stores all you need for a game and doubles as a dice tray

Ocena
0 / 5
Polubienia
6
Pobrania
106
Wydruki
0
Wyświetlenia
696
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Here is a battle box of my own design which I use to store most of my parts for Age of Sigmar games. The box is a simple stacking system which comprises the following components:

  • A large dice tray which houses the other components. I have allowed a little extra tolerance so that you can install some felt to the bottom of this (in my case, two layers of hobbycraft felt)
  • An insert to hold 180 12mm D6s (I run skaven if that wasn't obvious!). I may upload a v2 of this with less dice storage
  • An insert to hold 50 16mm D6s and your warscroll cards. I designed this to fit the skaven warscroll deck exactly with its cover. It also has a hole in the bottom to assist retrieval. 
  • An insert which slots onto the 16mm D6 insert which acts as a mini score card and 3" measurer storage
  • A simple sliding lid embossed with some AoS themed logos. I don't have an MMU but this could be done nicely with one.

Everything has been designed with the end user in mind and kept as simple as possible. There are helpful grab handles on all the inserts to assist with retrieval and a handy tolerance for felt inserts to the dice tray. 

Print instructions

All of this has been designed to be easily printed with no supports on a standard MK4s/Core one/MK3s etc. bed. A small version is in the works and I will upload soon. I also intend to extend the insert lineup to accommodate other faction specific parts and fewer/alternative dice inserts.

I have test printed in both PLA and PETG but found for the largely indoor purposes that PLA is sufficient. The print in the photos was completed in Prusament galaxy black PLA at a 0.2mm layer height and with no supports. As always, i strongly recommend switching to gyroid infill.

Any feedback or criticism would be greatly appreciated as I am still fairly new to this!

Tagi