1 / 1
XL Calibration Pin Holder for 3D Upfitters Enclosure — zdjęcie 1

XL Calibration Pin Holder for 3D Upfitters Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount the XL calibration pin on the 3D Upfitters Enclosure

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
24
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

With the Prusa XL enclosure from 3D Upfitters, there is no space to store the calibration pin on the side filament sensor. However, you can print this to store the calibration pin on the outside of the enclosure.

This prints in place without supports. Due to heat, I do not recommend printing this in PLA; use something more heat tolerant like PETG, ABS or ASA.

To install, remove top and front screws from the top left corner bracket, place this calibration pin holder, then replace and tighten the screws.