Solder Fume Extractor - USB-C and Einhell/Ozito battery
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the base to use USB-c or Einhell powertool battery
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 374
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Redesigned the base to accept a Einhell PowerXChange battery. I also added a PD USB-c module so I could power it of I hadn't a battery at hand.
Used a Stepdown converter so I could regulate the voltage from 18v of the Einhell battery to 12V.
I used a different PWM fan controller module because it was a bit smaller, and a 6pin switch so I could power the fan without the voltage of one source reaching the other components, if I didnt do that, the usbc module would power up the step-down converter.
EDIT: On the wiring image, I forgot to draw a black wire going from the battery holder negative to the IN- on the stepdown converter. I'll change it when I have time.
Also I my design doesn't use threaded inserts. I don't feel they are neccesary since the screws can grab on to the 3d print just fine, just make more walls arount the holes using a modifier in the slicer. I leave the .f3d file if you want to make any modifications.
Also printed Regis side clips