1 / 3
Anycubic Kobra S1 Right Side Poop Chute and Bucket — zdjęcie 1
1 / 3

Anycubic Kobra S1 Right Side Poop Chute and Bucket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A right side poop chute with the end screw bottom mounted and chute extended, as well as a poop bucket.

Ocena
3,667 / 5
Polubienia
73
Pobrania
985
Wydruki
4
Wyświetlenia
3933
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Poop Chute:
The chute will print on the Kobra S1 build plate diagonally with some rotating. I've added a 3mf file with the print oriented already. 

Update: I've created a “5cm” version that is deeper than the original (3cm). Sometimes, poop that is too big would get stuck at the top. This deeper version should give more clearance and allow for the poop to pass into the chute. Note poop bin has not been updated for the new version. 

Poop Bin:
I created a custom poop bin based on my version of the chute. I use a .75 inch Rubber Paver Pad underneath my Kobra S1, and the “with pad” model accounts for this increase in height so that the poop bin is directly at the height of the chute.

If you are not using a rubber paver pad, just print the standard bin. 

The bin has a line on the side to align with the back of the printer. 

Remix Details: 
I made a combination of the designs by Pro-JG and MisterTLX. I found that poop would get stuck at the end of the chute in the design by MisterTLX due to the mounting point being in the path of the chute. Pro-JG's model has the mounting point below the chute, so poop would not get stuck. I did however appreciate the full enclosure of the exit point in MisterTLX's design so I included it in my model. I also extended the end of the chute to bring it closer to the edge of the printer.

Tagi