1 / 4
Wolfcraft clamp connector
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Connector to extend capabilities of one-hand Wolfcraft clamps by joining two together.
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 80
- Wydruki
- 1
- Wyświetlenia
- 380
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (39)Powiązane
This is a part allowing to connect two one-hand type Wolfcraft clamp together to extend their reachibility.
It is composed of :
- One connector
- Two thumb screws “cap”
You will need in addition :
- 2 M6x30 (or longer) hexagonal head screws
- 2 M6 bolts (5mm thick)
- 2 Wolfcraft one-hand type clamps
For printing I recommend :
- PETG but I think PLA can do as well
- Print the connector in “length” not in “height” meaning base on the large rectangular face
- Grid and 100% infill (I tried 55% gyroid but it broke due to high constraint when clamping)
- Enable supports (you will need a flat screwdriver to remove it from the inside)
Assembly is straight forward but I suggested gluing the bolts into their holes as well as the screws in their thumb screw caps.