1 / 5
RSA Badge holder with Voronoi design and top stop guard — zdjęcie 1
1 / 5

RSA Badge holder with Voronoi design and top stop guard

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Voronoi design RSA Badge holder with stop guard on top

Ocena
5 / 5
Polubienia
7
Pobrania
115
Wydruki
0
Wyświetlenia
501
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Loved the design from @Tim_166963 but my badges would fall out the top end. I move around a lot so needed something more secure.. 

The holder can fit 3 badges snuggly with 1 RSA holder. 

2 badges works great with a little wiggle room. 1 badge is totally fine too, more space but it wont fall out.   

 

Printed at 15% standing up with snug supports using the everywhere setting. This did put supports inside the cavities but they popped right out with a toothpick. Prtin time was 1hr 40mins at 100%

Tagi