Propane Tank Support v1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Propane Tank Support
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 103
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
This is an older version of my Propane Tank model, see the new version here:
https://www.printables.com/model/1471223-propane-tank-support-v2
I modeled this to help raise my propane tank in up and allow my Mopeka Tank Sensor to have room an not hit the ground.
There are 3 sizes included. 1.5, 2.0, 2.5 mm which is referring to the tension nubs in the groove for the tank foot. I had 4 tanks and i found even the same model tanks seem to vary a little so I just referenced these.
I used PETG and ABS to print these. If you want a 1 size fits all, I would recommend perhaps using the 2.0 mm and use TPU.