Ruger Mark 4 Target holster for inserts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A very open holster for the Mk 4
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 335
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
A very open holster for the Mk 4, purely for the range. I am a novice modeler so the model is far from perfect, but it fits my needs.
You will require two M3 inserts for the holster and two M3 screws to screw the belt part to the holster itself. I don't remember which length screw was used, but I think 15mm is close.
I have included both a right-hand and left-hand version since some of us shoot with the correct side. :D
If the fit is loose, add a bit of felt on the inside (either furniture feet pads or those small, round, sticky rubber dampener things one gets with Ikea cupboards) to create more friction. You still can't run or exercise with it.
I have included a couple of belt loops: a small version, a longer 150mm, a 150 with a 7.5 degree tilt and one with extra supports round the base.
My friend (who has the printer) suggests printing the belt loop using "extra perimeters" and perhaps PETG also.