1 / 1
12" Guitar Speaker Mounting Hole Jig for Speaker Cabinet — zdjęcie 1

12" Guitar Speaker Mounting Hole Jig for Speaker Cabinet

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Helps align and drill the hole pattern for a 12" guitar cabinet speaker.

Ocena
0 / 5
Polubienia
6
Pobrania
28
Wydruki
0
Wyświetlenia
307
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Standard Digital File License

This model was created to help align and drill the holes for a 12" speaker for a guitar cabinet project. The jig fits an 11" diameter hole for a 12" speaker. The jig has a small lip on the bottom that fits into the 11" speaker hole.

Helpful features:

  • The jig has a straight edge for aligning the hole pattern to the speaker cabinet front baffle. 
  • Holes sized for 0.281" drill bit (size K) to fit threaded inserts (McMaster #92105A014) for #10-32 screws
  • An extra set of 0.281" holes are offset 10 degrees, allowing for the jig to be pinned for the larger set of 0.500" (described below)
  • A set of larger 0.500" holes are offset 10 degrees from the speaker hole pattern. These holes are to help align and drill the 0.500" counterbore for the threaded inserts mentioned above. The extra 0.281" holes allow the jig to be rotated and pinned in place to align these 0.500" holes for the counterbore operation
  • Jig and hole patterns are labeled
  • Springs optional (two models available, one with, one without) incase the speaker hole diameter is slightly larger than 11".

 

Instructions for use:

  1. Insert jig into 11" diameter hole
  2. Align straight edge square to speaker baffle
  3. Tape jig in place with painters tape
  4. Drill 0.281" drill pattern #1 holes
  5. Optional: Drill one or two of the 10 degree offset holes for a pin
  6. Optional: Rotate the jig and insert a pin in to the alignment hole
  7. Optional: Use the larger 0.500" pair of holes to make a very shallow counterbore using a 0.5" forstner drill bit for each speaker mounting hole (Pattern #1)
  8. Optional: Rotate the jig 180 degrees to drill the other to locations with the forstner bit

 

Printing:

  • 3 perimeters
  • 15% infill, triangle pattern
  • Printed in PETG, which worked fine, but a more rigid material may be easier to align
  • Requires large print bed, e.g. Prusa XL printer

 

 

Tagi