Carry handle for Segway NINEBOT MAX G3

I modeled this handle to carry this scooter more easily by one hand, if mounted as in photo, its quite balanced. If you want, you can print one piece of “Handle clamp hole” so you can carry your allen key here as in photo. I've been using it for more than month and it works great.

You can also check out my other model: Handlebars for Segway NINEBOT MAX G3

Additional hardware:

2x M5x25 socket head screw

4x M5x16 socket head screw

2x M5 DIN 7349 washer 

6x M5 DIN 562 nut

Blue Loctite Threadlocker

Print settings:

Printed from PETG or ASA 

25% infill

8 perimeters

Use pause print at layer for insertion of the nuts

Use Fuzzy skin function on outer walls of “Handle scooter” for added grip.

Print:

1x Handle scooter

2x Handle clamp 2

2x Handle clamp or optionally replace one piece by Handle clamp hole

Assembly:

 I recommend to use blue Locktite on all bolts to prevent loosening

Put washer into the “Handle clamp 2” followed by M5x25 bolt, attach it to the handle, repeat for second piece

Put handle with attached clamps to the scooter stem, where you want it and put second half of clamp on , screw in two M5x16 bolts until they catch the nut in the other piece, then align your handle with the scooter wheel and tighten the bolts. Do not over tighten so you dont split the clamps, it helps to tighten both sides at the same rate.

Repeat for lower clamp