1 / 2
Anderson PowerPole system for Eco-Worthy LiFePo4 30Ah — zdjęcie 1
1 / 2

Anderson PowerPole system for Eco-Worthy LiFePo4 30Ah

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I wanted to have PowerPoles so I didn't need to keep undoing the battery posts. It's rough-and-ready but does a job!

Ocena
0 / 5
Polubienia
11
Pobrania
55
Wydruki
0
Wyświetlenia
662
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is a rough-and-ready make. I was doing a POTA and wanted to have Anderson PowerPoles instead of exposed battery terminals. Since printing mine, I've refined the design a little, but the main elements are all there. 

The PowerPoles are retained by two posts and side guards, plus a little lip at the back. The cables can be cable-tied in the main bridge section.

The sections are printed individually, and the bridge section slides into the boxes for the terminals, and if you use 20A cable, the cable will hold it all in place nicely. The bridge section should have supports on the bed for the two end pieces.

I've done two tops, one with LiFePo engraved, and one plain. 

When printing the battery post covers, mirror one on the X axis to fit the curved corners.

I printed the covers upside-down on a smooth plate to avoid needing any supports.

I printed mine on Bambu A1, smooth plate, PETG, 0.2 standard, with supports on bed for the bridge, and everything else standard settings.

Tagi