Print in Place Cascade Wallet/Kickstand CMF Phone 2 Pro Case with ID Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A print in place case for the CMF Pro Phone 2 with integrated cascade wallet and ID holder.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 595
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a case for the CMF Pro Phone 2 with an integrated, print in place cascade-style wallet that also has a built in ID holder and functions as a kickstand.
The wallet holds up to six cards, although in my experience works best with at least five cards, and is sized to fit standard driver's license sized IDs.
To Make -
Print the “PiP Wallet Phone Case - Wallet” sitting upright, ideally at the lowest layer height you're capable of. I've made it work up to .28mm but it's far from ideal, the best luck I've had is at 0.08mm layer heights. Make sure to turn off supports, and if your slicer gives you a warning about floating sections or cantilevers that's just fine and entirely intentional so ignore it.
Once it's printed squeeze the lever's axis back and forth until you feel it pop loose and make sure it moves smoothly through its entire range of motion. Very carefully pry the hinged back open as well - I recommend starting by inserting a thin object between the two pieces near the top hinge and gently coaxing it open. The hinges are slightly thin and can be broken in the initial opening if you're not careful although after this they're robust enough for long term use, especially when affixed to the case.
After you have the mechanisms working insert your cards into the wallet, there will probably be fairly significant resistance at first as they're friction fit into place. Run the mechanism, pushing the cards in and out, a few times to loosen it up. It will also flex slightly as the cards sit in place and loosen over the next day or two. If it remains too tight you can scrape along the inside wall of the wallet with a knife to shave off fractions of a millimeter and loosen the hold slightly. Do this slowly and carefully, checking the fit frequently, as it can be easy to shave off too much if you're forceful which will leave you with cards falling out.
Print the “PiP Wallet Phone Case - Case Back” and “PiP Wallet Phone Case - Camera Protector” face down on the build plate, again at the smallest layer height you can because they're very thin.
When printed, mate the wallet to the case back by inserting the locating fin on the wallet into the corresponding slot on the case. Glue the wallet in place with an appropriate glue (something containing dicholormethane, also known as methylene chloride, for PLA or PETG if you want a solvent weld - or gorilla glue if not; acetone or superglue for ABS or ASA) taking care not to get glue into the hinge especially if you're using gorilla glue which will puff as it cures.
Do the same with the camera protector, permanently fixing it in place.
When it's all together install the case onto your phone, put your cards and ID into place, and you're good to go.