VZBot dual Z mod V2 width belt tension
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
With this mod you can keep the bed from sagging and use the z-tilt option
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 300
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
If you have the aluminium bed and have bed sagging because of the heavy load, then this is for you. This is V2 of my old adapter plate that is inspired by the original dual-z adapter but with a close loop belt and an ½ gearing.
Hardware used:
2x GT2 5mm 20 teeth pulley
2x GT2 8mm 40 teeh pulley (measure your z-rod diameter and get the ones that fit to it)
8x M3 14 screws
2x GT2 closed loop 122mm belt
2x 608ZZ bearing
2x M5 Nut
2x M5 30mm screw
For Klipper:
Make sure that you modify your printer.conf in the z_stepper section with the following:
rotation_distance: 4
For other firmwares:
Don't know exactly where to modify the settings but you have just to double the rotation output :)