1 / 1
Flashlight pressure switch holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a friction-fit holder for the pressure switch power switch for a flashlight.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 69
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I bought a flashlight with a pressure switch / power button. I then wanted to Velcro the switch in place, however, the rubberized cover on the switch is too slick for adhesive to stick to it. So I designed this VERY SIMPLE slip-fit holder since the adhesive-backed hook/loop will stick to PLA much better.
Dimensions:
- The opening for the pressure switch is 16.3 mm wide
- The side sections that wrap over the top of the switch are around 4.9 mm
- The slot is 54.4 mm long (that's how far switch will slide into the holder)
- Overall width:
- V1 is 20 mm
- V2 is 22 mm (I made it a little wider to fit my location better)
- The rubberized cover has a bit of pliability so it squeezes in nicely
- Edges are filleted/rounded over to avoid harsh corners when pressing the switch
Printing Notes:
- Layer Height - I printed mine at .1mm layer height, but do what makes sense
- Adaptive Layer Height - review the model in your slicer before printing to understand where thin layers might be (probably around the top where the filets are.
- Z seam - check seam location settings and review the preview in your slicer since the model doesn't have any hard corners to hide the seam.