40cm fullsize 3in1 Latern - (for wallmount, hanging or standalone) - use LED-Lamp only
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 3-in-1 garden light. It can be used as a wall light, a floor lamp (25mm standpipe), or as a pendant light.
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 92
- Wydruki
- 0
- Wyświetlenia
- 631
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
This garden light can be used as a floor, wall, or hanging light.
It is approximately 40 cm high, making it a full-size fixture. It is prepared for an E27 socket. Please use only LED bulbs (otherwise, excessive heat generation is expected).
The material is PETG. The files include a template for the discs, as well as printable discs for transparent PETG. The template is slightly smaller and is designed to create truly transparent discs from 2 mm polyacrylic from a hardware store using a cutting disc, which greatly enhances the lamp's appearance.
PVC-U/Tangit and screws M3.5 x 8mm are required.
The garden light is designed for a 25 mm standpipe too.
Material: PETG
10 Steps to build
Tip: When inserting the discs, first insert the disc into the lower guide, bend the disc slightly and press it into the upper guide
Pull the cables through the openings before gluing!
_
______________________________________________________________________________________________________________
For example, you can find suitable lamps for 12V AC/DC here:
https://www.ebay.de/itm/315749007693?var=614174638533
For example, you can find suitable E27-lamp holder here:
For example, you can find suitable screws here:
https://www.ebay.de/itm/261203482741?var=566918263822
_______________________________________________________________________________________________________________
Printing tips
Use brim and tree for all parts.
Place the supports diagonally on the plate (see picture below).
When printing, use printing-glue for all parts – for example, I use Dimafix spray glue.
Currently printing PETG slowly
